Cloyes Quick Button Timing Cover Manuel d'utilisateur télécharger pdf

Installation Instructions

Cloyes Quick Button

Timing Cover

BEFORE YOU BEGIN: READ ALL OF THESE INSTRUCTIONS FIRST !!!

Note: The installation procedures which follow assume that the engine has been

disassembled and cleaned as it would be for a normal timing cover change.

YOU WILL NEED:

TOOLS:

5/32" Hex Bit Socket or Hex Wrench

3/16" Hex Bit Socket or Hex Wrench

Inch-Pound Torque Wrench

5/16" Flat Blade Screwdriver

SUPPLIES:

(10) 1/4-20 x 1/2 Socket Head Cap Screws

Front Main Oil Seal

1. Clean everything! Make sure that the engine mounting surfaces and timing cover

components are as clean as possible. Oil leaks may result unless all surfaces are

clean.

2. Prepare the Engine. Loosen the oil pan bolts enough so that the new timing cover

can be installed without damaging the gasket. Push the camshaft sprocket firmly

against the engine block to remove any endplay.

3. Install the Oil Seal. Carefully tap the oil seal (not supplied) into the timing cover

from the front side. Tap the seal in place until it is flush with the timing cover. Be

sure to keep the seal straight in the cover.

4. Install the Timing Cover. Mount the Timing Cover over the aligning pins on the

engine block. Use a small amount of gasket sealer if desired. Install the ten (10)

mounting screws (not supplied). Torque these screws to 160 in-lb (13 ft-lb) using

your 3/16" Hex Wrench.

5. Install the Adapter Plate and Quick Button

Cam Button. Remove the locking

screw from the center of the adapter plate and turn the Quick Button

cam button

1 2

Page 2

Pas de commentaire

Cloyes Quick Button Timing Cover Manuel d'utilisateur