Cloyes Hex-A-Just 9-3145B (SB Chevy Factory Roller and Ca Manuel d'utilisateur télécharger pdf

April 29, 2009

Installation Instructions

9-3145B Hex-A-Just® True Roller Timing Set

BEFORE YOU BEGIN: READ ALL OF THESE INSTRUCTIONS FIRST !!!

Note: The installation procedures which follow assume that the engine has been disassembled

and cleaned as it would be for a normal timing set change.

YOU WILL NEED:

TOOLS:

1/4" Hex Bit Socket or Hex Wrench

Torque Wrench

Hammer

Sleeve to fit over crankshaft for installing Crankshaft Sprocket

Degree Wheel (Optional, but Recommended)

SUPPLIES:

Assembly Lube or Camshaft Lube

Thread Locking Compound (LockTite® #271 or equiv.)

1. Prepare the Engine. Loosen all rocker arms so that the camshaft can rotate freely.

2. Clean everything! Make sure that the engine mounting surfaces and timing set

components are as clean as possible. The life of the chain and sprockets depend on it.

3. Mount the Crankshaft Sprocket. Select the appropriate keyway for the camshaft timing

baseline desired. We recommend the Standard Timing position, which used the round

timing mark and round keyway mark. Carefully tap the sprocket onto the crankshaft using

a sleeve to protect the sprocket. Make sure that the sprocket is fully seated on the

crankshaft. Rotate the crankshaft until the appropriate crankshaft sprocket timing mark is

in the 12:00 position. Make sure that the number one piston is at top dead center.

1 2

Page 2

Pas de commentaire

Cloyes Hex-A-Just 9-3145B (SB Chevy Factory Roller and Ca Manuel d'utilisateur