Cloyes Hex-A-Just 9-3110A (BB Chevy) Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Pour la voiture Cloyes Hex-A-Just 9-3110A (BB Chevy). Cloyes Hex-A-Just 9-3110A (BB Chevy) User Manual Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 2
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
April 24, 2009
© Copyright 2007, Cloyes Gear Company. All rights reserved. 9-3110A 1
Installation Instructions
9-3110A Hex-A-Just® True Roller Timing Set
BEFORE YOU BEGIN: READ ALL OF THESE INSTRUCTIONS FIRST !!!
Note: The installation procedures which follow assume that the engine has been disassembled
and cleaned as it would be for a normal timing set change.
YOU WILL NEED:
TOOLS:
1/4" Hex Bit Socket or Hex Wrench
Torque Wrench
Hammer
Sleeve to fit over crankshaft for installing Crankshaft Sprocket
Degree Wheel (Optional, but Recommended)
SUPPLIES:
Assembly Lube or Camshaft Lube
Thread Locking Compound (LockTite® #271 or equiv.)
Cloyes Cam Button (Part Number 9-200 or 9-202) (Optional, but Recommended).
1. Prepare the Engine. Loosen all rocker arms so that the camshaft can rotate freely.
2. Clean everything! Make sure that the engine mounting surfaces and timing set
components are as clean as possible. The life of the chain and bearings depends on it.
3. Mount the Crankshaft Sprocket. Select the appropriate keyway for the camshaft timing
baseline desired. We recommend the Standard Timing position, which used the round
timing mark and round keyway mark. Carefully tap the sprocket onto the crankshaft using
a sleeve to protect the sprocket. Make sure that the sprocket is fully seated on the
crankshaft. Rotate the crankshaft until the appropriate crankshaft sprocket timing mark is
in the 12:00 position. Make sure that the number one piston is at top dead center.
4. Insert the Hex-A-Just
®
Timing Bushing.
Insert the offset bushing (with the Hex hole) into
the slot in the camshaft sprocket hub. Rotate it
with a 1/4" Hex Wrench so that the timing mark
on the bushing points away from the center of
the hub (Figure 1). The Hex-A-Just
®
Adjustable
Timing Bushing is infinitely adjustable so you
can fine adjust you engine's CAMSHAFT
TIMING to EXACTLY WHERE YOU WANT IT.
Vue de la page 0
1 2

Résumé du contenu

Page 1 - Installation Instructions

April 24, 2009 © Copyright 2007, Cloyes Gear Company. All rights reserved. 9-3110A 1 Installation Instructions 9-3110A Hex-A-Just® True

Page 2

April 24, 2009 © Copyright 2007, Cloyes Gear Company. All rights reserved. 9-3110A 2 5. Install the Camshaft Thrust Bearing. Install the T

Commentaires sur ces manuels

Pas de commentaire